Search results for "Enginyeria química"
showing 10 items of 16 documents
Biotrickling filter modeling for styrene abatement. Part 1: Model development, calibration and validation on an industrial scale
2017
Abstract A three-phase dynamic mathematical model based on mass balances describing the main processes in biotrickling filtration: convection, mass transfer, diffusion, and biodegradation was calibrated and validated for the simulation of an industrial styrene-degrading biotrickling filter. The model considered the key features of the industrial operation of biotrickling filters: variable conditions of loading and intermittent irrigation. These features were included in the model switching from the mathematical description of periods with and without irrigation. Model equations were based on the mass balances describing the main processes in biotrickling filtration: convection, mass transfe…
Recovery of Lithium Carbonate from Dilute Li-Rich Brine via Homogenous and Heterogeneous Precipitation
2022
An extensive experimental campaign on Li recovery from relatively dilute LiCl solutions (i.e., Li+ similar to 4000 ppm) is presented to identify the best operating conditions for a Li2CO3 crystallization unit. Lithium is currently mainly produced via solar evaporation, purification, and precipitation from highly concentrated Li brines located in a few world areas. The process requires large surfaces and long times (18-24 months) to concentrate Li` up to 20,000 ppm. The present work investigates two separation routes to extract Li+ from synthetic solutions, mimicking those obtained from low-content Li+ sources through selective Li+ separation and further concentration steps: (i) addition of …
Performance of polyester-based electrospun scaffolds under in vitro hydrolytic conditions: From short-term to long-term applications
2019
The evaluation of the performance of polyesters under in vitro physiologic conditions is essential to design scaffolds with an adequate lifespan for a given application. In this line, the degradation-durability patterns of poly(lactide-co-glycolide) (PLGA), polydioxanone (PDO), polycaprolactone (PCL) and polyhydroxybutyrate (PHB) scaffolds were monitored and compared giving, as a result, a basis for the specific design of scaffolds from short-term to long-term applications. For this purpose, they were immersed in ultra-pure water and phosphate buffer solution (PBS) at 37 °
Bone Fusion in Normal and Pathological Development is Constrained by the Network Architecture of the Human Skull
2016
The premature fusion of cranial bones, craniosynostosis, affects the correct development of the skull producing morphological malformations in newborns. To assess the susceptibility of each craniofacial articulation to close prematurely, we used a network model of the skull to quantify the link reliability (an index based on stochastic block modeling and Bayesian inference) of each articulation. We show that, of the 93 human skull articulations at birth, the few articulations that are associated with nonsyndromic craniosynostosis conditions have statistically significant lower reliability scores than the others. In a similar way, articulations that close during the normal postnatal developm…
Mining minerals and critical raw materials from bittern: Understanding metal ions fate in saltwork ponds
2022
Seawater represents a potential resource for raw materials extraction. Although NaCl is the most representative mineral extracted other valuable compounds such as Mg, Li, Sr, Rb and B and elements at trace level (Cs, Co, In, Sc, Ga and Ge) are also contained in this “liquid mine”. Most of them are considered as Critical Raw Materials by the European Union. Solar saltworks, providing concentration factors of up-to 20 to 40, offer a perfect platform for the development of minerals and metal recovery schemes taking benefit of the concentration and purification achieved along the evaporation saltwork ponds. However, the geochemistry of these elements in this environment has not been yet thoroug…
Sustainable recovery of critical elements from seawater saltworks bitterns by integration of high selective sorbents and reactive precipitation and c…
2023
The availability of raw mineral resources containing elements included in the Critical Raw Materials (CRMs) list is a growing concern for the European Union. Sea mining has been identified as a promising secondary source. In particular, brines obtained in solar saltworks (bitterns) contain relevant amounts of valuable CRMs such as Mg(II), B(III), other alkaline/alkaline earth metals (Rb(I), Cs(I), Sr(II)) and transition/post-transition elements (Co(II), Ga(III), Ge(IV)). However, the low concentration of some of these elements (µg/L) requires an effort to develop recovery routes that are sustainable and economically feasible where the required chemicals and energy are produced on-site from …
Subsurface nitrate reduction under wetlands takes place in narrow superficial zones
2017
This study aims to investigate the depth distribution of the Nitrate Reduction Potential (NRP) on a natural and a re-established wetland. The obtained NRP provides a valuable data of the driving factors affecting denitrification, the Dissimilatory Nitrate Reduction to Ammonium (DNRA) process and the performance of a re-established wetland. Intact soil cores were collected and divided in slices for the determination of Organic Matter (OM) through Loss of Ignition (LOI) as well as Dissolved Organic Carbon (DOC) and NRP spiking nitrate in batch tests. The Nitrate Reduction (NR) was fitted as a pseudo-first order rate constant (k) from where NRPs were obtained. NR took place in a narrow superfi…
Biotrickling filter modeling for styrene abatement. Part 2: Simulating a two-phase partitioning bioreactor.
2017
Abstract A dynamic model describing styrene abatement was developed for a two-phase partitioning bioreactor operated as a biotrickling filter (TPPB-BTF). The model was built as a coupled set of two different systems of partial differential equations depending on whether an irrigation or a non-irrigation period was simulated. The maximum growth rate was previously calibrated from a conventional BTF treating styrene (Part 1). The model was extended to simulate the TPPB-BTF based on the hypothesis that the main change associated with the non-aqueous phase is the modification of the pollutant properties in the liquid phase. The three phases considered were gas, a water–silicone liquid mixture, …
Poly(N-isopropylacrylamide) and Copolymers: A Review on Recent Progresses in Biomedical Applications.
2017
The innate ability of poly(N-isopropylacrylamide) (PNIPAAm) thermo-responsive hydrogel to copolymerize and to graft synthetic polymers and biomolecules, in conjunction with the highly controlled methods of radical polymerization which are now available, have expedited the widespread number of papers published in the last decade—especially in the biomedical field. Therefore, PNIPAAm-based hydrogels are extensively investigated for applications on the controlled delivery of active molecules, in self-healing materials, tissue engineering, regenerative medicine, or in the smart encapsulation of cells. The most promising polymers for biodegradability enhancement of PNIPAAm hydrogels are probably…
Evaluation of the Purity of Magnesium Hydroxide Recovered from Saltwork Bitterns
2022
Magnesium has been listed among the 30 critical raw materials by the European Union. In recent years, many green and sustainable alternative Mg2+ sources have been sought to satisfy the EU’s demand and to avoid mineral ore consumption. In this context, saltwork bitterns, the by-products of solar sea salt production, have attracted much attention thanks to their high Mg2+ concentrations (up to 80 g/L) and low Ca2+ and bicarbonate contents (<0.5 g/L). Although investigations on Mg2+ extraction from bitterns in the form of Mg(OH)2(s) have already been performed, product purity has never been properly addressed. Mg(OH)2(s) is a chemical compound of great interest and extensive utility in num…